Dynamic range enhancer & tape noise reduction system

Introduced in 1970’s, as  improved version of model 118

Front panel (from left to right):  Power switch – Power red light – Above threshold/Linear switch – Operating level (2 V to 10 mV) – Compression/Expansion ratio – Below/Above pilot lamps- Dynamic range enhancer (pre/post) – Noise reduction (rec-bypass-play) – Play level match – Tape/disc selector.

Introdotto negli anni settanta, quale versione migliorata del Modello 118.

Pannello frontale (da sinistra a destra) Pulsante accensione – Luce accensione-  Pulsante Above threshold/Linear  – Operating level (2 V to 10 mV) – Manopola Compression/Expansion ratio – Luci spia Below/Above – Dynamic range enhancer (pre/post) – Noise reduction (rec-bypass-play) – Play level match – Tape/disc selector.

Rear panel (from left to right): Quad coupler [or compressing or expanding four channel programs, connect coupler jacks of two DBX] – RECORD SECTION: Inputs from tape out of preamp – Rec Level Match [this screwdriver control is factory adjusted to match the record levels encountered in most home stereo equipment] – Outputs to tape aux or line input – PLAY SECTION: Inputs from tape output – Output to tape in or tape monitor of preamp.

 

Available on request the owner’s manual. 

LINK

Wikipedia: DBX Noise Reduction

Pannello posteriore (da sinistra a destra): Accoppiamento quadrifonico [per comprimere o espandere un programma a quattro canali, connettere i jack coupler di due DBX] – SEZIONE REGISTRAZIONE: Ingressi dal tape out del pre – Livello segnale registrazione [ questo controllo a vite è regolato in fabbrica per i livelli di uscita della maggior parte degli impianti stereo] -Uscita per l’ingresso aux o line in del registratore. SEZIONE RIPRODUZIONE: Ingresso dal tape out del registratore – Uscita per il tape in o tape monitor del preamplificatore.  

Disponibile a richiesta il manuale dell’utente. 

LINK

Wikipedia: Il sistema DBX di riduzione del rumore